Enable-IT 868 Instrukcja Użytkownika Pobierz pdf (Strona 30)

December 2003

3-4 Programming Site Data

Entering the ACTIV Mode

Note: It is not necessary to enter the ACTIV menu to operate the

PT868, as the flowmeter automatically runs in Transit-

Time mode.

The first option in the Program Menu is ACTIV, which enables

you to select the Transit-Time mode of measurement. (On a

PT868-R flowmeter, the option enables you to choose between

the Transit-Time and Transflection modes. The Transflection

option is not available for the PT868.) Refer to Appendix D,

Menu Maps, Figure D1-A for a flow diagram of the ACTIV

option. To enter the ACTIV option, press [F1]. The screen

appears similar to Figure 3-2.

Figure 3-2: Screen After Pressing ACTIV Key

Press [F1] to select Transit-Time, or your may at this time do one

of the following:

• Continue to enter data using other Program Menu options as

described in this section.

• Save the entered parameters as described on page 3-32.

• Press the [EXIT] key to begin taking measurements. If you

press [EXIT] without saving, the TransPort gives you the

opportunity to save. Refer to page 3-32 to save the site data.

PROGRAM Start

PROGRAM

status

SITE STATUS

Transit

TRANS

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 245 246

Brak uwag

Enable-IT 868 Instrukcja Użytkownika Strona 30