Enable-IT 868 Instrukcja Użytkownika Pobierz pdf (Strona 37)

Programming Site Data 3-11

December 2003

Entering System Parameters (cont.)

12.Setting the Time

The last prompt in SYSTeM asks you to set the time. You can

accept the currently displayed time by pressing [F1], or change it

as described below:

a. Press [F2] to edit the time.

b. Use the numeric keys to enter the hour.

c. Press the appropriate feature key to select AM or PM, and

press [ENT].

d. Use the numeric keys to enter the minutes, and press

[ENT].

e. Use the numeric keys to enter the seconds, and press

[ENT].

You have completed entering system parameters. You may now

do one of the following:

• Use the [↑ ] and [↓ ] arrow keys to verify or change data.

• Continue to enter data using other Program Menu options as

described in this section.

• Save the entered parameters as described on page 3-32.

• Press the [EXIT] key to begin taking measurements. If you

press [EXIT] without saving, the TransPort gives you the

opportunity to save. Refer to page 3-32 to save the site data.

If you decide to exit, you must have already programmed the pipe

parameters in order to make flow measurements.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 245 246

Brak uwag

Enable-IT 868 Instrukcja Użytkownika Strona 37